Aquatec 8851 Series Ro Booster Pump 24vac 8851-2j03-b421 + Transformer

  

ONE (1) NEW AQUATEC 8851 SERIES RO BOOSTER PUMP WITH 3/8 JG INSERTS. ONE (1) NEW 8800 TRANSFORMER 115V. (requires Adobe Reader: it's free). At Checkout and Receive Your Item in.

Don't pay more for less! We charge you less than our competitors charge you for slower service. We will match all verified competitor's prices. This pump is usually used to boost water supply pressure to a Reverse Osmosis water system. If your water supply pressure is below 40psi, you should add this pump to your RO system.

This water booster pump is to boost the input water pressure. It is usually used to increase the input water pressure for Reverse Osmosis systems.

(boost pressure to 60 to 80 psi). This pump is suitable for RO systems that. Use up to a 120GPD membrane.

For RO systems, an increase in input pressure means an increase in. RO systems will run more efficient, with less waste water. Since it uses a pressure switch and solenoid valve to turn on/off the water input, it can turn on and turn off more accurately than the mechanical auto shut-off valve. For large water containers or an open water tank, you can use a float switch or level switch to control the operation of the pump. Aquatec's original product, and still the "global standard" in booster pump technology, providing reliable inlet pressure for efficient membrane utilization.

These pumps are capable of continuous duty and are effective for recirculation based applications as well. They are ideally suited to work with hydro-pneumatic storage systems but are.

Compatible with most hydraulic shut-off valves also. These pumps are commonly used with one or more of Aquatec's flow control compon. Switches (PSW Series), tank level controllers TLC.

Series or electronic shut-off valves (ESO Series). System is not working properly. The CDP, Continuous Duty Pump, runs continuously. See IMI 156, Automatic Shut Off Valve's effect on the PSW's shut off ability.

The pump that delivers water from the holding tank to the refrigerator is noisy. Water than the icemaker can accept (usually about 1/4 gpm at 35 psi), and is momentarily. Use a lower flow pump, and add an accumulator between.

The pump and refrigerator if necessary. Pumps selection chart, section A, for recommended choices.

What effect does feed pressure have on the tank/faucet pressures? The flow of water to the membrane will increase, but 80 psi pump discharge. Pressure will not change due to the preset by pass pressure. What effect does higher by-pass pressures have on tank/faucet pressures? Since the pressure entering the membrane has increased, so will the pressure exiting.

The membrane, at the expense of flow, however. Based on 95% rejection of TDS levels at 600 ppm and 60 psi membrane feed pressure.

In a 70 degree F ambient environment. The boost pump output pressure is only 60psi? Assuming you have not adjusted the by pass setting, you may be using a membrane. With a permeate production higher than the pump can supply.

Either switch to a higher. Flow pump, or go to a lower rated membrane. Are low feed pressure shut off switches (LPS) available? The LPS comes with the appropriate wire harness, but a tee with a 1/8 NPT female. Center port is not provided.

Aquatec's transformers are both current and temperature protected for additional safety protection. Aquatec pump-transformer combinations are designed to operate at maximum efficiency under a wide range of voltage conditions without overheating or overloading. This can save the end-user thousands of kilowatt hours per year compared to less efficient pumps. New Aquatec replacement tranformer for 8800 series booster pumps. Designed and manufactured by Aquatec to ensure compatibility and proper operation. Output Voltage Max: 24 VAC.